When storing and transport the PC sheets , be careful not to scratch or damage the edge of the board. All plates shall be packed, transported and stored according to the following methods.
During transportation and storage, it must be properly padded and packed, and shall not be stored in the place where it can be exposed to sunlight or rain;
During transportation, and the carriage shall be kept clean. In order to prevent the scratch and breakage of the board edge and protective film, the four corners shall be wrapped with paper or cloth strips. During transportation, paper should be placed under the board to prevent scratching the board surface.
PC Sheet is covered with protective film. When carrying and installing, the side of the board with UV protective layer should face the sun. Before installation and use, do not remove the protective film to prevent scratching the surface of the board
The room should be dry, well ventilated, clean and dust-free. The stacked boards should be sealed as far as possible to prevent the dust in the air from falling into the board and the moisture in the air from forming moisture condensation in the board, and should not be in direct contact with the cement floor to avoid corrosion of the board.
