If you are cutting the solid polycarbonate sheet in the production workshop, you can use professional cutting tools, such as circular saws, hand saws, bows, etc. It is more common to use circular saws with fine-tooth saw blades to cut endurance boards, which can more accurately grasp the size and use it more quickly. When cutting, pay attention to the sawdust, because the endurance board does not have anti-static properties. When the sawdust is released into the air, it will go to the endurance board. It is difficult to clean up after cutting. When cutting, dry compressed air can be used to blow out the grooves, so that the sawdust will not be emitted into the air, and the endurance board after cutting can be kept clean and tidy.
Manual or motorized hacksaws are often used at the construction site. The endurance board should be fixed and clamped on the table to avoid vibration during cutting. The protective film does not need to be removed first to prevent cutting and scratching to the surface of the board. This endurance board cutting mode is more convenient when there is no large cutting machine.
Precautions for cutting endurance board
1. When cutting, pay attention to the endurance board not to get chemical solvents. If it does, you need to wipe it off with a soft cloth moistened with alcohol immediately, otherwise it may crack first.
2. If the surface of the endurance board is dusty, rinse it off first and then wipe it dry with a cloth.
3. It is best not to tear off the protective film first when cutting, and tear off the protective film only after installation to avoid scratches on the surface of the endurance board.
4. Note that the endurance board can not be placed on the wet concrete floor for a long time, and avoid contact with acids, alkalis and other liquids.
5. After cutting, it should be placed in a cool place, not exposed to the sun, it is best to store in a ventilated and dark room.
